A ledger is typically a 2 by 4 or larger piece of lumber attached to a wall or other surface with the use of fasteners such as nails or screws.
Attach ledger board to concrete block.
Line up the pilot holes in the board with those on the block.
To attach a ledger against a wall through brick veneer.
Yes there are products available for anchoring a ledger board to hollow concrete block foundations concrete masonry unit cmu.
Beginning from one end drive one 2 1 2 inch tapcon style concrete screw through each pilot hole in the board and into the cinder block.
Position the ledger against the wall and mark the anchor positions through the hole onto the wall.
Ledger boards are used to make joints between lumber structural elements and other materials.
Mark these locations on the wall with a pencil.
Can i attach my deck to a hollow block concrete foundation.
With the ledger board firmly in place against the cinder block it is now ready for you to attach the joist hangers and complete the deck installation.
This wood strip allows other pieces to be joined to the wall with relative ease.
Things needed measuring tape.
Five ledger board techniques explained and illustrated.
When attaching a ledger board to a masonry wall you will want to first cut the ledger board to size and have two helpers hold it in place so you can drill two holes every 12 through the wood where your bolts will be installed.
Repeat for each hole making sure that each screw is run all the way in until the head is flush.
There are no fasteners that are approved for attaching a deck ledger to a hollow block wall.
The only correct way to fasten a ledger to a hollow wall is to sandwich the block with another ledger board inside the house.
There are a handful of manufacturers that produce epoxy and other adhesive anchors that are tested for use in hollow cmu.
Hold the ledger board in place on the cinder block.
This is a time consuming process and should be done while the house is being constructed to simplify the process and reduce costs.
Viewing 20 posts 1 through 20 of 38 total.
Mark anchor locations on your ledger and drill through the board with a bit.
Attaching a ledger board to concrete block this topic has 37 replies 1 voice and was last updated 4 years 1 month ago by jponto07.